PS-5V-200W
5V 200W LED Power Supply (40A)
5V 200W 40A LED power supply for indoor modules.
- 5 V DC
- 40 A
- 200 W
US$7–9 / pcMOQ 2 pcs
Full specification
Neutral · PS-5V-300W
5V 300W LED Power Supply (60A)
5V 300W 60A LED power supply for indoor and outdoor modules. 87–88% efficiency, 110/220V input, short-circuit and over-temperature protection.
Sixty amps at 5V is the volume seller of the LED power market. It suits one 960×960 outdoor cabinet, or 6–7 m² of P4 outdoor module at 60% load, and fits the standard rear panel without modification.
Ask for the measured efficiency on the batch you receive. The printed figure is often 87%; cheap units measure 82%, and the difference shows up as heat inside the cabinet rather than on the invoice.
- 60A continuous at 5V
- 87–88% efficiency
- Fits standard 960×960 cabinet panels
- Screw terminals for 6 mm² cable
Specification
| Output voltage | 5 V DC |
|---|---|
| Output current | 60 A |
| Rated power | 300 W |
| Input | 110/220 V AC selectable |
| Efficiency | 87–88% |
| Ripple | ≤ 180 mV p-p |
| Protection | OVP, OCP, SCP, OTP |
| Dimensions | 215 × 115 × 50 mm |
| Warranty | 2 years |
Where it goes
- Outdoor cabinets
- Indoor large walls
- Rental frames
Questions on this line
One per cabinet?
For a 960×960 outdoor cabinet at P4, yes. At P5 or P6.67 the load is lower and one unit covers it with headroom.
110V operation?
Yes, via the side switch. Set it before installation — it is not reachable once the cabinet is closed.
Also in Power Supplies
All power supplies Related lines
PS-5V-400W
5V 400W LED Power Supply (80A)
5V 400W 80A LED power supply for high-load outdoor cabinets.
- 5 V DC
- 80 A
- 400 W
US$14–18 / pcMOQ 2 pcs
Full specification
PS-4.2V-300W
4.2V 300W LED Power Supply (71A)
4.2V 300W 71A LED power supply for common-cathode indoor modules.
- 4.2 V DC (adjustable 4.0–4.4 V)
- 71 A
- 300 W
US$11–15 / pcMOQ 2 pcs
Full specification
Buying this line in volume?
Send the quantity and the destination port. Tiers start at 100 pcs and drop again at 1,000; DDP pricing needs the postcode.